3, Hidemyphone Installer Installation Instructions
1, Download 01 suitable Hidemyphone Installer version then extract:
1 - INSTALL TWRP
Connect the phone with the computer > turn off the power > hold 3 buttons Bixby + Power + Volume Minus simultaneously to enter the screen as below:
Press Volume Plus to enter DOWNLOAD MODE screen as shown below:
Open Odin software.
Pay attention to the ID:COM port: If it's blue up like the picture below, go to the next steps. If not, please check if you have installed the Samsung USB Driver, or check the cable, USB port.
Options section: Remove Auto Reboot tick:
Import file twrp-3.4.0-0-starlte.img.tar into AP button:
Click Start to install TWRP.
If it shows Pass as the picture below, then done:
2 - INSTALL ROM Hidemyphone and GApps
Hold simultaneously Bixby + Power button + Volume Minus to power off then quickly hold Bixby + Power button + Volume Plus to go to the TWRP screen (as below) > Swipe Swipe to Allow Modifications:
Choose WIPE:
Choose Format data:
Type Yes > Enter:
Go to the next step, do not reboot the phone.
Open HidemyphoneInstaller software:
Click Find Devices to show the device information:
There are 03 options, choose 01 of the 03 buttons to install:
Install Rom + Settings to install Rom, Gapps and phone settings (If you download Hidemyphone Installer 800mb version, click it).
Install Rom + Gapps to install Rom and Gapps. Note that:
In this case you have to manually enable ADB and configure the phone according to your wishes.
Enable 2 options as follows after enabling ADB:
Install Stock + All: Click it if you use Hidemyphone Installer - full options version. The software will install Rom Stock before installing Rom Hidemyphone like when pressing Install Rom + Settings.
Wait for the software to install for about 5 minutes. The status is shown below is successful:
*PLEASE DO NOT LOCK THE SCREEN, AVOID ERROR.
Last updated